20301852
42
DVBL7 Series Gas Fireplace
LoG & roCK wooL INStaLLatIoN
Figure 54 -
Rock wool placement
roCK wooL PLaCeMeNt
1. Place rock wool on burner to provide glowing
embers. For best results, pull the rock wool apart
into pieces the size of a dime or smaller.
2. Distribute one layer of rock wool to cover the burner.
Figure 53
3. Place the logs on the burner. Refer to
Log Placement
below. Light unit and after 15 minutes, check burner
flame and glow. Refer to
Burner Flame
, Page 44.
If the flame is blue and only in the center, turn off unit
and let cool. After unit cools, remove logs. If the back
holes are clear, add more rock wool to the center of the
burner. Replace logs and check flame again. Save left
over rock wool to refresh when cleaning later. Too much
rock wool can disturb the flame and cause sooting on
the glass or logs.
LoG PLaCeMeNt
1. Place the rear log (#1) in place by sliding it over the
rear pins on the right and the left.
2. Place the left front log (#5) over the burner and grate
by matching the holes on the bottom of the log with
the pin on the burner. Also match the cut-out on the
bottom of the log with the bars on the grate.
Note:
When this log is in place pull towards the front.
3. Place the right front log (#4) over the burner and grate
by matching the hole on the bottom of the log with the
pin on the burner. Also match the cut-out on the bottom
of the log with bars on the grate.
Note:
When this
log is in place pull forward.
4. Place the front upper right log (#3) on top of the front
log by matching the rectangular notch on the bottom
of this log with the rectangular protrusion on top of the
front right log. Slide this log toward the middle of the
burner until the pointed end comes in contact with the
pointed end on the left front log.
Note:
It is critical
to place this log properly, otherwise it will affect the
flame and the performance of the unit.
hearth BrICK PLaCeMeNt
Place the hearth brick centered in front of burner and slide back until it hits the stops on the right
and left of burner.
FP2340
BDVL base
Figure 53 -
Placement of Rock Wool on Burner
Cover with
Rock Wool
Burner
FP2340
w
ar
NING
Do not use the entire bag of rock wool
to cover the burner. this could cause
the flame to burn poorly and may lead to
sooting.
LG648
BLDV ember place
LG648
f i r e - p a r t s . c o m
