4
57D0215
380IDV/490IDV Fireplace Insert
IMPORtANt SAFety INFORMAtION and CODe APPROVAl
Continued from page 3
12. Do not use this insert to cook food or burn paper or
other objects.
13. Never place anything on top of insert.
14. Do not use any solid fuels (wood, coal, paper, card-
board, etc.) in this insert. Use only the gas type indi-
cated on rating plate.
15. This appliance, when installed, must be electrically
grounded in accordance with local codes or in the
absence of local codes, with the
National Electrical
Code, ANSI/NFPA 70
, or the
Canadian Electrical Code,
CSA C22.1.
16. Do not obstruct the flow of combustion and ventilation
air in any way. Provide adequate clearances around
air openings into the combustion chamber along with
adequate accessibility clearance for servicing and
proper operation.
17. Do not use insert if any part has been exposed to or has
been under water. Immediately call a qualified service
technician to inspect the appliance and replace any
part of the control system and any gas control which
as been submerged in water.
18. Do not operate insert if any log is broken.
20. Do not operate the insert with glass door removed,
cracked, or broken.
CODe APPROVAl
Direct Vent type appliances draw all combustion air from
outside of the dwelling through the vent pipe.
These appliances have been tested by CSA and found to
comply with the established standards for DIRECT VENT
GAS FIREPLACE HEATERS in the USA and Canada as
follows:
lISteD VeNteD GAS FIRePlACe heAteR
TESTED TO: ANSI Z21.88b-2008/CSA 2.33b-2008
STANDARDS
A manufactured home (USA only) or mobile home OEM
installation must conform with the
Manufactured Home
Construction and Safety Standard,
title 24 CFR, Part
3280,
or when such a standard is not applicable, the
Standard for Manufactured home Installations, ANSI/
NCSBCS A225.1
, or
Standard for Gas equipped Recre-
ational Vehicles and Mobile housing, CSA Z240.4
.
WARNING
!
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
W
ARNING
Never connect unit to private (non-utility)
gas wells. this gas is commonly known
as wellhead gas.
IMPORtANt:
PleASe ReAD the FOllOWING
CAReFully
It is normal for fireplaces fabricated of steel to
give off some expansion and/or contraction noises
during the start up or cool down cycle. Similar
noises are found with your furnace heat exchanger
or car engine.
IMPORtANt:
PleASe ReAD the FOllOWING
CAReFully
It is not unusual for gas fireplaces to give off some
odor the first time it is burned. This is due to the
manufacturing process.
Please ensure that your room is well
ventilated during burn off — open all
windows.
It is recommended that you burn your fireplace
for at least ten (10) hours the first time you use it.
Place the fan switch in the “OFF” position during
this time.
Содержание 380IDVNVC
Страница 37: ...57D0215 380IDV 490IDV Fireplace Insert 37...