MIGE2210 Series Gigabit Din-rail Switch
- 15 -
of the two MIGE2210-2GF-4S/M devices are connected by fiber cables. Each
device is connected to a 100-Mbps Tx port through a direct-connected network
cable and tested. The computers are connected, and the ping packets are sent
to each other in the computer console, and both parties can correctly ping each
other without losing packets. At this time, if the computer network card is 10M,
then the network port speed light (yellow light) connected to the computer
should be off; if the computer network card is 100M, then the switch is
connected to the computer with the network port speed light (yellow light) )
should be always on, so the green light (link/ack light) on the port should be
flashing. If you see the above phenomenon, the two 100M Fx port of the tested
hardware are working properly.
Figure 5-4 Schematic diagram of the 100M Fx port test connection
5.6. Network Connection
MIEN2210 series industrial Ethernet switches are equipped with 8 100M
Ethernet ports and 2 Gigabit Ethernet ports. Each RJ45 port can be directly
connected to the terminal device, or it can be connected to another industrial
Ethernet switch/hub in front of the terminal device. Used as a shared
connection. As shown below.
Figure 5-5 Network connection diagram
