MIEN1203/MIEN2205 Industrial Ethernet Switch
- 7 -
MIEN1203/ MIEN2205/ MIEN2205-S/M provides the terminal equipment
10Base-T/ 100Base-TX Ethernet RJ45 interface, which uses a straight-chain
network cable to connect to the terminal equipment, and a crossover network
cable to connect to the network equipment.
Connect the power supply
MIEN1203/MIEN2205/MIEN2205-S/M devices use power according to the
instructions on the product label. When all other cables are connected, you can
connect to the power supply.
3.3. Fiber optic connection
MIEN1203/MIEN2205-S/M provide 100Base-FX full-duplex single-mode
or multi-mode fiber interface. The type of optical fiber interface can be selected
as SC/ST/FC according to requirements.
Warning:
This switch uses lasers to transmit signals on fiber optic cables. The laser meets
the requirements of Class 1 laser products, and normal operation is harmless to
eyes. However, when the equipment is powered on, do not look directly at the optical
transmission port and the end face of the optical fiber terminator.
The steps to connect the pluggable fiber optic module are as follows:
Remove and keep the rubber cover of SC/ST/FC port. When not in use,
put on a rubber sleeve to protect the optical fiber terminator.
Check whether the optical fiber terminator is clean. Slightly moisten a
clean paper towel or cotton ball, and gently wipe the cable plug. Dirty fiber optic
terminator will reduce the quality of optical transmission and affect port
performance.
Connect one end of the optical cable to the optical fiber interface, and
the other end to the optical fiber interface of another device.
After the connection is completed, please check the corresponding
LINK/ACT indicator of the optical port on the front panel. If the indicator is on,
the connection is valid.
