Maier MHI-6220, Инструкция по эксплуатации

Страница: 4 / 8

4
OPERATING INSTRUCTIONS
1. Insert the end (hollow plug) of the cable of the AC/DC adapter into the DC socket
(Marked as DC12V) on the side of the air purifier (The DC adapter is for vehicle use only).
2. Insert the adapter in the electric socket or the vehicle’s cigarette lighter socket.
3. Press the power switch, which will activate the red LED light on the other side of the
purifier. You will be able to see a blue glow at the tip of a few of the electrodes inside the
grill. You will also hear and feel a slight blowing from the electrodes.
4. Press the LEVEL-adjusting switch to adjust the “HI” or “LO” operating mode.
Settings
1. “ON” “HI” - runs at full capacity; green LED lights up.
2. “ON” “LO” - Automatically runs in intervals of 2 minutes “on” and 3 minutes “off”; yellow
LED lights up.
3. “OFF”.
CLEANING AND MAINTENANCE
Make sure unit is unplugged before performing any maintenance!
1. Cleaning the Dust Collection Plate
The dust collection plate should be cleaned about every 20-30 days. Cleaning the dust
collection plate is very simple to do. You just need to loosen the two screws that hold the
dust collection plate in. Then you just need to pull the dust collection plate out, and wipe it
off with a damp cloth. You should then wipe it off with a dry towel, and reinsert it back into its
slot. If there is difficult-to-remove residue on the plate, you should use a household cleaner ,
such as ammonia or bleach, to help remove it.
CAUTION
Plate’s edges are sharp so please use a towel or thick fabric to avoid injuries.
Note: When removing the collector plates for periodic cleaning, please note that it must be
returned to the unit in exactly the same position for a flush fit. Reversing the position will
result in an incomplete closure and the unit will not function properly.