INSTRUCTION MANUAL FOR DISHWASHERS
Page 10 of 14
UK
N.B. Do not switch off the machine if a regeneration cycle is underway
4.12
Displaying information
By holding the
START
button (
4
) pressed for a few seconds you can display in sequence the Boiler
temperature, the Tub temperature and the number of cycles performed by the machine.
This information can be displayed both before and during the wash cycle and will only be visible
temporarily.
By holding the
PROGRAMME SELECTION
button (
3
) pressed for a few seconds you can display in
sequence the Boiler temperature, the Tub temperature and the number of cycles performed by the
machine.
The function can be activated by holding the
PROGRAMME SELECTION
button (3) pressed for a
few seconds
.
4.13
List of viewable messages
Door open
Number of cycles
carried out
Rinse temperature
End of cycle
Wash temperature
Automatic start
enabled
Regeneration cycle or request
Continuous wash
No salt in the softener
Service
4.14
End of shift
At the end of the day always drain the machine as described in the section Machine draining.
Disconnect the power supply by means of the main switch and close the external water cock.
Perform routine maintenance and clean the machine as described in the section Maintenance.
If possible, leave the door ajar to prevent bad odours building up inside the machine.
