INSTRUCTION MANUAL FOR DISHWASHERS
Page 8 of 12
UK
•
Rinse the area around the salt cap by hand and run a self-cleaning cycle to avoid any risk of
corrosion.
•
The
‘ST’
warning will disappear after a few minutes.
The warning
rE
on the display indicates that the machine is running a resin regeneration cycle, needed
to ensure the correct operation of the water softener; while this warning is shown, the cycles run could
be longer than usual.
N.B. Do not switch off the machine if a regeneration cycle is underway
4.11
Displaying information
With the dishwasher on, press
PROGRAMME SELECTION
(
2
) for five
seconds, in sequence the following are shown:
•
“
t
” wash temperature
•
“
b
” rinse temperature
•
“
CC
” wash cycles carried out during the life of the dishwasher.
4.12
List of viewable messages
Door open
Number of cycles carried out
Rinse temperature
End of cycle
Wash temperature
Automatic start enabled
Short wash
Continuous wash
Medium wash
Final drain
Long wash
Regeneration cycle or request
No salt in the softener
4.13
End of shift
•
At the end of the day always drain the machine as described in the section Machine draining.
•
Disconnect the power supply by means of the main switch and close the external water cock.
•
Perform routine maintenance and clean the machine as described in the section Maintenance.
•
If possible, leave the door ajar to prevent bad odours building up inside the machine.
