INSTRUCTION MANUAL FOR DISHWASHERS
Page 10 of 10
UK
Chap 8
SCRAPPING
Our machines do not contain materials requiring special handling.
(Applicable in the EU and countries with sorted waste disposal)
The mark applied to the product or its documentation indicates that it must not be
scrapped with domestic waste when it reaches the end of its service life. To prevent
damage to the environment or health risks due to improper scrapping, keep this product
separate from other waste and recycle it so as to promote sustainable use of materials.
Domestic users are requested to contact their reseller or local authority for information on sorted waste
disposal and recycling for this type of product.
Corporate users are requested to contact their supplier and check the terms and conditions of the
purchase contract.
The product may not be scrapped together with other commercial waste.
Chap 9
ENVIRONMENT
RESPECT FOR THE ENVIRONMENT
Proper use of the dishwasher can improve its environmental footprint, if the following simple rules are
observed:
Only wash full baskets.
Switch the dishwasher off when not using it.
Keep the machine closed when it is in standby.
Use wash programmes suited to the amount of soiling.
Supply the machine with hot water, if gas heated.
Make sure the drains flow into a suitable sewer.
Do not exceed the recommended dose of detergent.
The manufacturer reserves the right to modify the electrical, technical and aesthetic features of this
appliance and replace any of its parts without notice, as he deems necessary to offer a reliable
product with a long service life and advanced technology.
Chap 7
DOSING UNIT SETTINGS
If the machine is equipped with dosing units, the settings can be changed as follows:
Machine in standby with door open.
Simultaneously hold pressed the
DRAIN (2)
and
START (4) buttons.
The
CYCLE LED (6)
will start flashing, thereby indicating the machine is in programming mode.
Press the
START button (4)
to adjust the DETERGENT dosing time; each press of the button is
equivalent to one second. The
POWER LED (5)
will flash at each press.
Press the
DRAIN button (2)
to adjust the RINSE AID dosing time; each press of the button is
equivalent to one second. The
HEATING LED (7)
will flash at each press.
Close the door and turn on the machine by pressing the
ON-OFF button (1)
, to save the settings.
Each time the machine enters programming mode, these settings will be erased.
