Issue: 1 - 01/03/2013
Page 10 of 12
XUV500
Wiring to the front of vehicle
Run the remaining lead behind the LHS cargo bay trim, being sure to
locate it low behind the trim to avoid fouling on mounting clips upon
reassembly.
Plug lead into video access plug in kick panel, tape
connection and cable tie off.
Test system and reassemble vehicle in full
.
Run lead behind pinchmould on wheel-arch and under
rear and front scuff trims . Secure the cable so it avoids
mounting clips on reassembly.
Using a screw driver, push the lead under the
bottom of the B pillar trim.
