Mahindra BOLERO NEO N10 2021, Руководство пользователя

Страница: 245 / 289

13-16
© Copyright Mahindra and Mahindra Ltd. 112020
• On account of any issue in signal reception or Tiretronics sensor
damage or tyres changed with out performing manual learning
then the signal will not be received
• Under such condition if the vehicle was driven for more than
certain value without signal being received at least once, then
‘Communication error’ will be set for respective tyre position on
the infotainment screen. The Tiretronics cluster telltale is also
illuminated to indicate the same.
• When the Tiretronics communication error is set then perform
manual learning once. If manual learning is not done successfully
then the corresponding position tyres sensor needs to be
checked by carefully opening the tyre
• If the sensor is found to be damaged then it should be replaced
with a new one and manual learning should be done
S Se en ns so orr F Fa au ullttyy/ / L Lo ow w B Ba atttte erryy A Alle errtt
The Tiretronics sensor in the vehicle tyres has an individual battery
internal to each sensor fixed. If the battery level is too low or the
sensor by itself is malfunctioning then the Tiretronics system shall
give this alert.
• If the Tiretronics sensor low battery/faulty is set then the
corresponding position tyres sensor needs to be removed by
carefully opening the tyre and replacing it with a new sensor
• Post replacing the new sensor, manual learning should be done
1 13 3..6 6..6 6 T Tiirre ettrro on niic css L Le ea arrn niin ng g
After tyre rotation or Tiretronics sensor replacement, the receiver
must be learnt, else the Tiretronics warning lamp indicates a
malfunction.
M Ma an nd da atte e P Po oiin nttss
Manual learning is the process by which the identities of 5 sensors
installed inside the tyres are learnt and programmed in to the
memory of the receiver module.
1.
Manual learning should be compulsorily performed on any of
the following conditions or operations done
• Any of the old Tiretronics sensors are damaged or sensors
are replaced
• Any of the tyres are replaced
• If any of the tyres or set of tyres are shuffled or swapped in
position
• If tyre rotation operation is performed
• If it is observed that the alert indications in the tiretronics
screen are not co-relating with respect to their actual
position in the vehicle
2.
Once manual learning is initiated, the sensors inside the tyres
need to be triggered by leaking the air from each tyre one at a
time and should be completed within certain value post to each
event for learning all 5 tyres
W WH HE EE EL LS S A AN ND D T TY YR RE ES S