Mahe MMS2000, Руководство пользователя

Страница: 21 / 36

MMS2000C 3
EN
2.
PUTTING INTO OPERATION
2.1. Connecting to the electric network
Check if the voltage stated on the device label complies with rated voltage of
alternate voltage of your electric network.
.
The device can be connected to electric socket equipped with protective contact installed by
authorized electrician. Current circuit of socket must be protected with 16Amp melting safety
fuse or circuit breaker.
2.2. Connecting the MIG/MAG torch
For torch connecting is used EURO Standard torch connector.
Please, tighten the connector well to eliminate the conduction losses. A loose connection can
cause damage of the machine and torch.
Never use damaged torch!
Make sure the contact tip match the manufacturer’s recommendations for type and diameter
of used wire. Connect the welding conduction main connecting plug into the main socket on
the front side. Secure it with the lock nut.
In case Teflon liner is used is it necessary to use contact neck liner out of brass to provide
good current conduction to the fill wire.