OPTIONAL COT ACCESSORIES – ASSEMBLY INSTRUCTIONS
by Mahar Manufacturing
2211 S. 28 St., Van Buren, AR
•
479-410-2211
•
www.4Legs4Pets.net
1. The Leg Tips are a snug fit so that they won’t fall off when the cot is moved. We suggest a
quick spray of water or Windex inside the Leg Tips so that they will slide onto the legs
easier.
2. Turn the cot upside down and slide the beginning of a Leg Tip onto the bottom of each leg
and gently push them into place. With a rubber mallet, gently hit each Leg Tip until it has
completely slid onto the legs. You may want to turn the cot right side up and step down
with your foot on each leg to help push the tip completely on.
Note: If the cot with rubber tips will be used outdoors without the Leg PLUGS – you may want
to drill a small hole in each rubber Leg Tip for water drainage. To remove the Leg Tips, apply
heat from hair dryer for a minute at a time until soft enough to remove by hand.
Leg Tips – Item #C-LegTip
The purpose of the Leg Tips is to help prevent the cot from sliding on smooth surfaces.
1. Place a Leg Plug into the large hole of each leg and gently push them into place. Place a
soft cloth over each Leg Plug and gently hit it with a rubber mallet 2-3 times each.
Note: The Leg Plugs must be securely inserted into the holes-this can only be accomplished
with the use of a rubber mallet. Pushing the Leg Plugs into the holes with your hand only will
result in them popping out over time.
Important! Observe your pet when the Leg Plugs are in place, to make certain they
are unable to remove the plugs. You may want to permanently glue the Leg Plugs in
place.
To remove (unglued) Leg Plugs, push end of unsharpened pencil through small hole in bottom
of legs.
Leg Plugs – Item #C-Plug-**
The purpose of the Leg Plugs is to cover the exposed large hole on the top of the legs.
(The holes enable the cot to be ‘nested’ when stacked, taking up less storage space).
316
