COT ASSEMBLY INSTRUCTIONS
&
PARTS LIST:
Mesh Cot Cover with cord attached (A)
(2) Long Side Bars (B)
(2) Short End Bars (C)
(4) Plastic Legs (D) (Dolly will have casters inserted)
COT AND COT DOLLY KIT ASSEMBLY INSTRUCTIONS:
*See Creative Colors instructional video at https://youtu.be/u6uLuOkEk08
*See 4Legs4Pets instructional video at https://youtu.be/K9J1dvp0y3U
1. Place Cover (A) upside down on flat surface (preferably on a table or floor)
2. Slide one Long Side Bar (B) through each long sewn “tunnel”. (If assembling a square cot, all rails will be the same size)
3. Slide one Short End Bar (C) through the short sewn ‘tunnel”.
4. Insert square ends of the Short End Bar (C) into Plastic Legs opening (D). You will hear a click, indicating that it is inserted
completely. (NOT PICTURED)
5. Insert square ends of the Long Side Bar (B) into Plastic Legs opening (D). You will hear a click, indicating that it is inserted
completely. (NOT PICTURED)
6. IMPORTANT: Pull the Cover (A) towards the open end, taking up the excess slack. (NOT PICTURED)
7. Insert square ends of remaining Short End Bar (C) into remaining Plastic Legs opening (D). You will hear a click, indicating
that it is inserted completely.
8. Lay Short End Bar (C) with inserted Plastic Legs (D) on top of the flap of the Cover (A) and insert one of the Plastic Leg (D)
opening into the square Long Side Bar (B) only 1/4 “. Now insert the other Plastic Leg (D) opening into the other square
Long Side Bar (B) only 1/4”. (Insert both ends only 1/4”, otherwise the cot won’t assemble properly). (NOT PICTURED)
9. Stand Cot upright with flap of Cover (A) on flat surface and with both hands grab top of cot in both corners and pull down.
This will ensure the rails are in the legs completely.
10. Lay Cot flat and place the Cover (A) flap over the Short End Bar (C) then lace the cord through the closest eyelet on flap,
then across to the eyelet on the strip, back through the eyelet on the flap, etc., pulling tightly as you are lacing it. (If you
don’t pull the lace tight as you are lacing, the lace may not be long enough to complete the assembly). Tie off in a knot.
11. If you have purchased the optional Cot Leg Tips and/or Cot Leg Plugs, please see opposite side for instructions on how
to put them on your cot.
To disinfect, use 1 part chlorine bleach to 2 parts water.
Can be rinsed off outside or in shower, but Do NOT submerge in water.
Air-dry —Do NOT lean or hang to dry.
3 (C)
4 (D)
9
7
2 (B)
2 (B)
10
1 (A)
6
by Mahar Manufacturing
4 (D)
5
8
Not Pictured
Not Pictured
Not Pictured
A quick spray of dry silicone to the ends of the rails makes
assembly a breeze!
2211 S. 28 St., Van Buren, AR
•
479-410-2211
•
www.CreativeColors.net
•
www.4Legs4Pets.net
