9
BA042501-en
Pos: 37 /Technische Dokumentation/Alle Geräte/Überschriften/Überschriften 1/B/Überschrift 1: Bedienung @ 6\mod_1174482271218_75.docx @ 76877 @ 3 @ 1
3
Operation
Pos: 38 /Technische Dokumentation/Alle Geräte/Überschriften/Überschriften 1.1/B/Überschrift 1.1: Bedienung über Pult/Aggregat (nur Gewichtssimulator) @ 34\mod_1382624945890_75.docx @ 1845811 @ 2 @ 1
3.1
Control via Desk/Power Unit (Weight Simulator only)
Pos: 39 /Technische Dokumentation/Bremsprüftechnik/MBT-SERIES/042501 MLS/BA/Inhalt: 0425 Bedienung über Pult/Aggregat (nur Gewichtssimulator) Teil 1 @ 25\mod_1313573450415_75.docx @ 1030979 @ @ 1
1 After switching on the brake tester, drive into the roller set with the selected
axle.
2 Set the switch with the “pull down” symbol on the brake
testers to position 1.
This sets the roller of the brake testers to ‘inactive’, and they can no longer start-
up or, if they have already started up, they will switch off.
3 Now switch on the pull-down mechanism at the main
switch (if available). When doing so, the switch for the di-
rection of travel (if available) should be set to position 0.
4 Bring the hydraulic cylinders into the upper 1/3.
Switch:
Turn the switch into the
position
↑
(release) or
↓
(tighten).
Then bring the
switch back into
position 0.
5 Hooking in the straps
There is an eyelet at the hydraulic cylinder that the tightening straps are pulled
through. Then place the straps around the vehicle axle and lash them moderately
tight by moving the handles up and down.
Improper hooking in of the straps may lead to damage of the axle or other parts
hooked in at the same time. This is why the straps must only be hooked in by
trained personnel! Avoid contact with sharp edges!
Once the straps have been hooked in properly and checked for correct fit, the
pull-down process can be started.
6 Tightening the pull-down mechanism.
Switch:
Turn the switch into position
↓
(tighten)
