Español Italiano Nederlands Français
English
Deutsch
11
Louise is a high-pressure system and comes with a reinforced hose, the „MAGU-
RA Disc Tube“ wearing also this imprint. The Disc Tube needs an additional insert for
a proper fitting. Never mix and match the parts from the
MAGURA Louise with the ones of our rim brakes or other manufacturers’ brakes! Any
misuse might cause serious accidents!
Never touch either the rotor or the brake caliper after long braking as
this may cause serious burns.
1.
Remove the wheel so that you have free access to the brake caliper.
Push both pistons
with brake pads mounted
back by putting the transport device or
a flat blade screwdriver into the gap. Move the screwdriver
slowly
back and forth until both
caliper pistons are fully retracted and flush with caliper body.
Never push back the pistons without the brake pads mounted! Open the brake
system only after having pushed back fully the brake pads.
2.
Loosen the brake lever clamping screw with a 5 mm allen key. Turn the brake lever
and ensure that
the reservoir points approx. 15° upwards from the horizontal
p
po
os
siittiio
on
n.
3.
Slide the hose protection. Unscrew the sleeve nut on the brake lever with an 8mm
open-end wrench and pull the hose out
carefully. Hold the hose carefully to avoid any
loss of oil! Do not squeeze the lever blade with the system open!
4.
Put the hose on a workbench and shorten it with a sharp knife. The best tool
is the MAGURA hose cutter.
Do not use saws or pliers!
6. Shorten the hose