w w w . m a g u r a . c o m
s e r v i c e @ m a g u r a . d e
w w w . m a g u r a . c o m
s e r v i c e @ m a g u r a . d e
18
19
13. Warranty
MAGURA is giving a 5 years leak proof warranty on brake levers (master cylinder)
and brake calipers. Watch out for the red order form of the warranty card in this manual
and order your warranty certificate.
This warranty is void when damage to the brake has occurred from the
following:
abuse
mixing and matching the brake with parts from other manufacturers
damage of the exterior finish caused by improper use
any attempt to disassemble the whole brake
modifications
non-factory changes or improper service
shipping damages or loss (purchase of full value insurance is recommended).
12. accessories
MAGURA disc brake service kit, code: 0721 294
contains everything that you need for bleeding and repairing a brake. ATTENTION: the kit
does NOT include a spare hose!
MAGURA braided hose for all MAGURA disc brakes
easily shortened
with a cable cutter, 1700mm
0° fitting:
code 0721 203
90°fitting:
code 0721 337
Watch out for the genuine hose with yellow MAGURA marker!!
Use only genuine MAGURA brake pads!
brake pads Clara Type 3.1 (left): code 0721 324
brake pads Julie Type 4.1 (right): code 0721 304
Use only genuine MAGURA accessories! Any parts manufactured by other
manufacturers like lever blades, hoses or brake pads have not been tested and
approved by MAGURA and consequently nothing can be said about their short
and long-term function. Never use those parts! All warranty and product liability
claims will be void in case of misuse!
Never change the paint, the finish or the consistence of your brake. This
might cause total failure of the whole system with possible heavy bodily injury!
problem
reason
solution
11. Trouble Shooting
not enough brake power
no pressure point
Squealing brake
contaminated brake pads
contaminated rotor
wheel cannot be mounted
rattling noise and rough
deceleration
leaking hose or brake
brake was not run it
oil/lubricants on rotor
and/or pads
air in the system
leaking systems
badly aligned frame
Paint/powder coating on
fitting eyelets
Wheel q/r skewer insuffi-
ciently tightened
Insufficiently tightened
wheel spokes
carelessness
carelessness
Lever blade was pulled with
removed wheel
brake pads worn, holder of
pads is wearing the rotor
accident, incorrect
installation
break in the brake (page4)
clean the rotor with warm
dishwater or alcohol replace
contaminated brake pads
bleeding the brake (page15)
Check hose connections and
hose for leaks; replace hose
if necessary (pages 14/15)
align brake caliper with
0,2mm spacers (page9)
remove any paint or powder
coating and care for an even
contact surface without
burrs. (page7)
Increase tightening of q/r
skewer and
mount it on
opposite side of caliper
.
check for an evenly spoked
wheel with high spoke
tension
brake pads must be changed
clean rotor with dish water
or alcohol
Push back the brake pads
with transport device or a
flat blade screwdriver.
(page12)
brake pad change (page 12)
change hose or defective
brake lever or caliper (page
14)
You will find further tips on our website www.magura.com in the FAQ
section!! Stay tuned.
