MAGUIRE Ultra-600, Установка, эксплуатация и обслуживание

Страница: 13 / 109

Maguire Products, Inc.
Rev. June 11, 2020
– ULTRA-600 Touchscreen
13
ULTRA By Maguire

- Ultra Low Energy Dryer
Engaging the Load Cells
The load cells are immobilized prior to shipping and must be engaged for
proper operation of the ULTRA-600 Dryer. There is a total of 4 load cells
on machine: 2 for the vacuum chamber and 2 for the retention hopper
Vacuum Chamber Load Cells
The first step in engaging the vacuum
chamber load cells is to remove the 2
retaining bolts that secure the vacuum
chamber to the frame.
Next, the jam nut located on the loadcell
transfer bolt needs to be loosened.
To engage the load cell, tighten down
the load cell transfer bolt until there is
roughly a ¼ inch (6mm) gap between the
hanger bumper stops and the frame.
Tighten down the jam nut to secure the
position and ensure proper load cell
engagement.
Repeat steps for the other side.
Retention Hopper Load Cells
To engage the Retention Hopper load cell
pair, remove the packaging straps from
the Retention Hopper Lifting Lever.
Lower the Retention hopper onto the load
cell by pressing the lever back and down.
This will engage the Retention Hopper
lower frame onto the load cell pair.
When the Retention Hopper Lifting Lever
is in its upright position, the lever's cams
lift the weigh off of the load cell pair and
allow the Retention Hopper to be pulled
out for servicing and cleaning purposes.