2 - Installation
tDynamo| Three-way Secure Card Reader Authenticator | Installation and Operation Manual
Page 19 of 39 (
D998200257-20
)
2.2.4
How to Connect tDynamo to an Android Host via Bluetooth LE
To connect tDynamo to an Android host that supports Bluetooth LE:
1)
Make sure tDynamo is configured to use Bluetooth LE as its primary connection. If it is configured
to use another connection, use that connection first to change the configuration.
2)
If any other Bluetooth LE host has an active data connection to the device, close the connection.
3)
On the Android host, install and configure the host software you intend to use with tDynamo. If you
do not yet have that software, you can download a test tool from the Google Play store called
MagTek Test
, published by
MagTek, Inc.
.
4)
Make sure tDynamo is powered on, is not in sleep mode, and that its battery is adequately charged
(see section
5)
Press and hold the pushbutton for 2 seconds until the General Status LED flashes three times, then
release the pushbutton to enter Pairing Mode. The General Status LED flashes blue up to 2 minutes
or until a host pairs or connects.
6)
On the Android host, launch the
Settings
application, and open the
Bluetooth
settings page or the
Connected Devices
>
Bluetooth
settings page.
7)
Make sure the host has Bluetooth turned
On
.
8)
Press the
SEARCH FOR DEVICES
/
Scan
/
Pair new device
button to show an
Available
devices
list.
9)
Locate the seven-digit serial number on the label on the back of the device.
10)
In the list of pairable devices, select the device called
tDynamo-xxxxxxx
, where
xxxxxxx
is the
device’s serial number.