Magtek IntelliStripe 65, Техническое справочное руководство

Страница: 13 / 44

Section 1. Features and Specifications
5
TEST LED
The Test LED is shown in Section 2, Figure 2-4. When the unit is powered up, the Test LED
will blink green. This indicates that the unit is in its standard operating mode.
FLASH UPGRADABLE
The unit’s firmware is in-system Flash Upgradeable. This allows the unit to be upgraded to new
smart card specifications.
RS-232 INTERFACE
The device can communicate to the host through an RS-232 interface. Once the host
communicates to the device on this interface the device will no longer be able to communicate
on any other interface until it is power cycled or reset. The device uses 8 data bits, 1 stop bit,
even parity. The device can automatically sync to baud rates 9600, 14400, 19200, 28800, 38400,
57600 and 115200. See MCP Driver Reference Manual (P/N 99875164), MCP Serial Transport
Protocol Reference Manual (P/N 99875163) and IntelliStripe 65 Command Reference Manual
(P/N 99875161) for more details.
USB INTERFACE
The device can communicate to the host through a USB interface. Once the host communicates
to the device on this interface the device will no longer be able to communicate on any other
interface until it is power cycled or reset. The device uses vendor identifier 0801 (hex) and
product identifier 000A (hex). The device contains a manufacturer string descriptor with a value
of “MagTek”. The device contains a product string descriptor with a value of “IntelliStripe 65”.
The device contains a programmable serial number string descriptor. The device does not get its
power from the USB port; it needs to be self powered. When using the USB port, power must be
applied directly to the PCB via the power connector or the host connector. See MCP Driver
Reference Manual (P/N 99875164), MCP Serial Transport Protocol Reference Manual (P/N
99875163) and IntelliStripe 65 Command Reference Manual (P/N 99875161) for more details.
SPECIFICATIONS
Specifications for the Reader are listed in Table 1-1.