5 - Removal and Re-installation
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 299 of 356 (
D99875607-91
)
Figure 5-154 - AC Filter Inside Case
6)
Reach into the left side access door and push the AC filter through the case until it hangs freely
outside the case (see
). If the cable is not long enough to expose the connectors outside
the case as shown, use the wire cutters or diagonal side cutters to carefully cut the cable tie that
anchors the cable to the bottom of the case.
Figure 5-155 - AC Filter Removed from Case, Still Wired
7)
Disconnect the cable from the AC filter. If the connectors are tight, loosen them by wiggling them
from side to side while pulling on the connector.
