5 - Removal and Re-installation
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 218 of 356 (
D99875607-91
)
5.21.3
Remove
To remove the embosser module from the ExpressCard 2000, follow these steps:
1)
Power on the device and open the top access door.
2)
On the touchscreen, navigate to
Menu
>
Maintenance
to open the
Maintenance Menu
page.
3)
If the device has a top indenter, press the
Unload Cartridge
button under
Top Indent Cartridge
to
move the front indent cartridge into the unload position. Remove the top indent cartridge and set it
aside in a secure location or give it to the customer for temporary storage or secure disposal.
4)
Press the
Unload Cartridge
button in the
Bottom Indent Cartridge
section to move the rear indent
cartridge into the unload position. Remove the rear indent cartridge by pressing the orange release
button. Set it aside in a secure location, or give it to the customer for temporary storage or secure
disposal.
5)
Prepare the device for replacing parts by following the steps in section
Device for Removing / Re-installing Modules
. At the end, the device should be powered down with
all external cables safely disconnected and the hopper shuttle parked near the front of the device.
6)
Remove the cover by following the steps in section
5.3 How to Remove / Re-install the Cover
7)
Carefully disconnect the embosser’s cable from the top deck, making sure not to break any wires.
shows the cable as seen from the left side of the device.
Figure 5-83 - Embosser Cable (TOP VIEW FROM LEFT)
8)
Use the diagonal side cutters or wire cutters to cut the cable ties that fasten the embosser cable to the
left latch cable next to it, and discard the cable ties.
9)
Re-route the embosser cable so the connector rests on top of the XY transport rails, as shown in
