Magtek ExpressCard 2000, Руководство по обслуживанию оборудования

Страница: 205 / 356

5 - Removal and Re-installation
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 205 of 356 ( D99875607-91 )
5.19.3 Re-install
To re-install the XY transport module, follow these steps:
1) Place the XY transport onto the top deck with the ground cable pointing toward the rear of the device,
lining up the holes in the XY transport module with the corresponding holes in the top deck plate.
2) Inspect around and underneath the XY transport to make sure it isn’t pressing any cables against the
top deck plate or other modules.
3) Make sure the four keys at the corners of the XY transport are seated in the corresponding slots in the
top deck plate (see
Figure 5-69 ). Push the base of the XY transport forward and backward, left and
right, to make sure they prevent it from moving around.
Figure 5-69 - XY Transport Base Keys and Top Deck Plate Holes (TOP RIGHT VIEW)
4) Move the XY transport carriage toward the rear of the device (see section 2.8 How to Safely Move
Transports By Hand ).
5)
Use the 1/8” hex wrench to fasten and tighten the
front three screws securing the XY transport to the
top deck plate (see Figure 5-64 ).
6) Move the XY transport carriage toward the front of the device (see section 2.8 How to Safely Move
Transports By Hand ).
7)
Use the 1/8” hex wrench to fasten and tighten the
rear three screws securing the XY transport to the
top deck plate (see Figure 5-64 ).
8) If the XY transport module you are replacing had the Indenter Ribbon Low sensor cable (see Figure
5-68 ), re-connect it and re-clip it. If it did not have that sensor, dress the extra sensor cable as
appropriate for the device you are servicing.
9) Re-connect the Y stepper connection cable (see Figure 5-67 ).
10) Re-connect the XY transport ribbon cable, with the cable coming off toward the front of the device as
shown in
Figure 5-66 .
11) Hold the ribbon cable in place in the middle of the clamp. Being careful not to pinch the cable, close
the clamp and press until you feel it lock closed.
12) Use the No. 2 Phillips screwdriver (and optionally the hemostat pliers) to re-attach the XY transport
ground cable to the top deck plate behind the image printer.
13) Re-attach the top access door by reversing the steps you used to lean it back.