![Magtek DynaFlex II Series Скачать руководство пользователя страница 43](http://html1.mh-extra.com/html/magtek/dynaflex-ii-series/dynaflex-ii-series_installation-and-operation-manual_3656174043.webp)
6 - Operation
DynaFlex II| Product Family | Installation and Operation Manual
Page 43 of 78 (D998200554-10)
6.6.4
How to Power On / Wake Up from Standby Mode / Power Off
To power on the device, press and hold the pushbutton for one second, or connect the device to USB
power. After powering on, devices with touchscreens show a page of information about the device, then
transition to showing the
Welcome
page or custom graphics, if they are configured to do so. For more
information about custom graphics, see
D998200383 DynaFlex Products Programmer’s Manual
(COMMANDS)
.
To power off the device, disconnect the device from USB power.
To reset the device, see section
If all LEDs are off, the device is in Powered Off mode, USB Suspend mode, or Standby mode. For details
about reading the status of the device with LEDs, see section
6.6.5
How to Force Reset
To force the device to reset, power it off then power it on again (see section
Wake Up from Standby Mode / Power Off
). Alternatively, you may use a small tool such as a paperclip
to carefully press the recessed switch inside the small hole on the bottom of the device (see section
Components on page
). The host may also reset the device by sending the
Reset
Device
command (see section
The device also automatically powers off if the rechargeable battery reaches a level that is low enough
that the device may not be able to complete a transaction.