Magnusson IM0301, Руководство пользователя

Страница: 6 / 52

6
CAUTION!
• ALWAYS turn off the instrument before replacing the batteries.
• ALWAYS remove the batteries if the instrument is not to be used for
extended periods.
• ALWAYS use high quality batteries of the same brand, type and age.
• If the instrument does not work properly, or the low battery icon is displayed,
replace the batteries immediately.
• DO NOT expose the batteries or instrument to extreme temperatures or direct
heat source, as this can cause the batteries to leak.
• If the batteries should leak, remove them using a cloth and dispose of them
according to local regulations. Clean any leaked battery acid avoiding any contact
with skin, eyes & mouth.
• If any contact does occur, rinse affected areas immediately with fresh water and
seek medical advice.
Functions and settings
01 Operation instructions
Your self-levelling cross-line laser level has two working modes.
Self-levelling mode
In this mode, the tool will level itself if it is within ±4° of horizontal.
Turn the tool on by sliding the Lock switch to the up position. The self-levelling cross-line laser level will automatically level
within 5 seconds.
Press the mode button until the desired laser-projection mode is achieved and the laser line is projected from the laser aperture.
If the laser level is greater than ±4°, the laser line will blink.
To turn off the laser lines, slide the Lock switch to down position. Press and hold the mode button until the laser shuts off.
Lock mode
This mode cannot be used to perform horizontal or vertical levelling, because the laser lines are no longer self-balancing.
In this mode, the LED indicator will always shine
.
1. Keep the Lock switch off.
2. Press the mode button to turn the laser on and to change the laser-projection mode.
3. To turn the laser off, press and hold the mode button until the laser shuts off.