Magnum MSD 1021, Инструкция по эксплуатации и каталог запасных частей

Страница: 7 / 16

7
OPERATING THE PUMP
1. Connect the discharge hose with the proper fittings.
2. Place the pump in the water. Lower by attaching a strong rope to the handle. The pump should be placed on a
flat, hard surface in at least 2 inches of water.
WARNING
Never lower or move the pump with the electrical cord. Damage to the cord or cord
seal could result in equipment damage and/or electrocution.
NOTICE
Do not install the pump on clay, dirt, or sand surfaces. Small stones, gravel, sand, and mud can clog the pump and
reduce the performance or cause malfunction of the pump. If necessary, place the pump on a concrete block or slab
to prevent the pump from sinking.
3. Connect the grounding-type plug to an outlet.
4. The pump should begin to cycle. To ensure proper operation, observe the pump to make sure it has enough
water to avoid cavitation.
WARNING
Never operate a pump or pump motor with wet hands. Never stand on a wet or damp
surface when operating the pump. Doing so could result in equipment damage or
personal injury.
WARNING
To prevent overheating, always keep the pump completely submerged when running
continuously. Running the pump continuously while not submerged could result in
equipment damage.
CLEANING THE PUMP
After running the pump, wash the pump in clean water. Keep inlet screens clean at all times, and always check the
screens before each use.
STORING THE PUMP
Please take the following actions in preparing the unit for storage.
1. Remove pump impeller cover and clean inside of pump housing. Coat inside of pump with a light film of oil to
reduce corrosion.
2. Tape up ports to prevent anything from falling into pump.
3. Store in a clean, dry area.