35
GENERATOR OUTPUT CONNECTION LUGS
The generator is equipped with connection lugs behind the lug box door located on the lower portion of the control
box. The lugs provide connection points for attachment of external loads to the generator. A large decal on the inside
of the connection lug door details the proper connections for selected voltages.
WARNING
It is HIGHLY RECOMMENDED that only a trained and licensed electrician perform any
wiring and related connections to the generator. Installation should be in compliance
with the National Electric Code (NEC) as well as any local or state guidelines as
required by law. Failure to follow proper installation requirements may result in
equipment or property damage, personal injury, or death.
WARNING
Before any connections are made to the generator, make sure that the main circuit
breaker and the engine start switch are in the OFF “O” position. Potentially lethal
voltages may be present at the generator connection lugs.
DANGER
IMPROPER OR INCORRECT CONNECTIONS TO A BUILDING’S ELECTRICAL SYSTEM
CAN CAUSE POTENTIALLY LETHAL VOLTAGES TO BACKFEED ONTO UTILITY
LINES. THIS MAY RESULT IN INJURY OR ELECTROCUTION TO UTILITY WORKERS
NEARBY. MAKE SURE THE GENERATOR IS SUPPLYING POWER TO AN ISOLATED
OBJECT OR BUILDING THAT IS NOT CONNECTED TO ANY UTILITY LINES.
Connections to the lugs should be made by running the power cables up through the slot in the bottom of the box.
Use a hex-wrench to tighten the cable connections. The connection lug door is equipped with safety interlock switches
that will trip the main circuit breaker and disable the voltage regulator if the door is opened while the unit is operating.
WARNING
Never attempt to disable or modify the lug door safety switches. Equipment damage,
personal injury or death may result.
A ground connection is located next to the connection lugs. The unit
MUST HAVE
this ground lug connected to a
good earthen ground for proper operating safety. The generator neutral is bonded to ground when it is shipped from
the factory. The bonding plate will need to be removed when the generator is used as a standby power source.
INSTALLATION SHOULD BE IN COMPLIANCE WITH THE NATIONAL ELECTRIC CODE (NEC), AS WELL AS
ANY STATE OR LOCAL GUIDELINES OR CODES.
RUN CABLES THROUGH SLOTS
Содержание MMG100D
Страница 5: ...This Page Intentionally Left Blank 5 ...
Страница 56: ...REV B PART NO 32668 03 15 13 ...