- 7 -
7
SETTING UP THE MD Internet
Media Tuner
1.
Position the tuner away from any spot
which may have extremes in
temperatures.
2.
Place the tuner on a very rigid surface
capable of holding 75 pounds (34 KG).
3.
It is important that the tuner is not covered
and it is not installed in a closed area
where there is little air circulation. Ensure
at least 2” of clearance on the left and
right of the device, and 5” of clearance
above the unit to allow for proper
ventilation.
4.
Connect the tuner to your preamplifier or
integrated amplifier using a set of cables
consistent with the caliber of your system.
Select the input you chose on your
preamplifier/Integrated.
Note: Be sure
that the preamplifier volume is set to
zero.
5.
If hardwiring your Internet Media Tuner ,
connect the Ethernet cable to the Ethernet
port, and the FM antenna cable to the RF
input, on the back of the unit.
6.
Unwrap the EIA AC cord and plug the
EIA end into the rear socket marked
Power Input
. Plug the other end of the AC
cord into a 120/220/230/240 volt
continuous AC power supply. Be sure that
the voltage marked on the rear of the unit
is the same as the AC source that you are
using.
** CHECK TO MAKE SURE THE UNIT
IS SET UP FOR THE PROPER
VOLTAGE **
(Check for unit’s voltage marked on rear
panel) then plug the tuner’s AC power
cord into an AC power source. Be sure to
use a continuous power source so as to
allow the stand-by mode feature to
function properly. The tuner’s audio
output is muted in the stand-by mode.
GO TO QUICK START
FEATURES OF THE MD 809
Magnum Dynalab has worked hard to create the perfect addition to your home listening
system while maintaining the impossibly high standards of quality Magnum Dynalab is
