MCC-35
4
2.1 Environment
Temperature
：
10°C to 35°C
Humidity: 30% to 70%
Altitude: Below elevation 1000m
There is no corrosiveness gas, flammable gas, oil mist and so on in room
2.2 Do’s and Don’ts
Do
-Read this manual and fully understand before the operation.
Do
-Check the
plug
and
machine voltage and frequency
to your main
supply, and that the socket has a correct working earth lead for this single
insulated machine
Do
use at least a 10 amp power source at 220 V. (20Amp/100V).
Do
make sure all
s
afety co
vers
are in place. The top covers have an
interlock switch which will disable the unit if removed
Do
open or close the cover slowly
Do
contact the local maintenance center before you are about to move
the machine.
Do
disconnect the power before clean the inner side.
Do
unplug the cord if you won’t use the machine for a long while,
Do
be careful of the blade edge
Don’t
install the machine on an unstable ground.
Don’t
operating with wet hand, especially plug or unplug the cord.
Don’t
wear long hair, loose fitting clothes or put your fingers into the
creasing unit nip, while the operation..
Don’t
place any receptacles with any liquid on any surface of machine.
Содержание MCC-35
