Magnum 28'' DISK, Руководство по эксплуатации

Страница: 19 / 43

M
AGNUM
-OP-EN - 19 -
MACHINE OPERATION
PRE-CLEANING CHECKLIST:
Read and understand the Safety Messages section on
Pages 3 and 4 before operating the machine.
1.
#HECK"ATTERY#ONDITION'AUGEONTHE#ONTROL0ANEL
Make sure Batteries are fully charged before using.
2. Check the condition of the Pads or Brushes.
3. Check the condition of the Squeegee Blades.
4. Raise the Scrubdeck and Squeegee before
transporting then transport the machine to the filling
station.
5. Turn the machine OFF . F F
6.
&ILLTHE4ANKWITHUPTOGALLONSOFCLEANWATER
either at the front fill port (A) or rear fill port ) (B) (SEE
BELOW) .
7. !DD APPROVED cleaning chemical to the Tank.
5SETHEPROPERDILUTIONRATIOINDICATEDONTHEBOTTLE
Contact us at 1(800)-634-4060 or +011-262-681-3583
if unsure.
NOTICE
The clear tube (Solution Sight Tube) (C) at the rear of the )
machine indicates the amount of water in the Tank (SEE
BELOW) .
DANGER
%80,/3)/.2)3+&LAMMABLEMATERIALSCANCAUSEAN
EXPLOSIONORlRE$O./4USEmAMMABLEMATERIALSIN
Tank or pick up.
CAUTION
TO AVOID DAMAGE TO THIS MACHINE:
t
5SE!002/6%$DETERGENTSONLY
t
7ATERTEMPERATUREMUSTNOTEXCEEDƒ&ƒ#
t
Do NOT use high-percentage Bleach mixture
OPERATING HINTS:
1. Observe the amount of solution the machine is
DISPENSINGONTHEmOORANDADJUSTTOTHEDESIRED
mOW4OINCREASETHESOLUTIONmOWRATEPRESSTHE
Solution Control Toggle up. To shut the solution OFF
completely, just release the Drive button, or use dash
mounted switch.
2.
+EEPANEYEONTHECLEAR6ACUUMCOVERTOMAKESURE
that there is not any foamy buildup in the Recovery
Tank. If excess foam begins to develop, pour a
recommended foam control solution into the Recovery
4ANK&OAMISUSUALLYANINDICATIONOFEXCESSIVESOAP
3.
!LWAYSOPERATEATLOWERSPEEDSWHENSCRUBBING
AROUNDWALLSANDOBJECTS9OUSHOULDREDUCETHE
speed to maintain control when turning.
4. If Squeegee starts to streak, raise and wipe the Blades
with a clean cloth. if the problem continues, check the
Squeegee Blades for wear or damage and rotate if
NEEDED9OUMAYNEEDTOPRESWEEPBEFORESCRUBBING
(Only Use OEM Parts)
5. Change or turn over Brushes / Pads when dirty.
6.
3TAYCLEAROFOBJECTSPROTRUDINGFROMTHEmOORSUCHAS
sockets, grates, etc, for they will damage the Brushes /
Pads and Squeegee Blades.
7.
!LWAYSKEEPANEYEONYOURGAUGES4HEYLETYOU
know the status of a particular system at a glance.
If your battery gauge is reading low you much stop
immediately and recharge. Running the Batteries
dead will result in damage to the Batteries.
8. 7HENYOURUNOUTOFSOLUTIONRAISETHE3CRUBDECKAND
continue to Vacuum the remaining water until it is all
consumed. The Solution Sight Tube is used to indicate
the level of detergent remaining in the Tank.
9. 7HENYOUAREREADYTOSTOPRAISETHE3CRUBDECKTURN
OFF the solution switch, raise the Squeegee and drive F
the machine back to the charging area. Be sure to
drain both Tanks before storing the machine.
A A
B
C C