Magnum Industrial MI-15550, Руководство по эксплуатации

Страница: 5 / 9

DANGER
Be sure to empty shop vacuum of all flammable material (flammable liquids and
vapors, paper, wood, plastic, etc.) before connecting vacuum to grinder. Hot sparks from
grinder may ignite flammable materials in shop vacuum.
OPTIONAL LIGHTED EYESHIELD
Positlon eyeshleld bracket assembly over bosses provided on wheel guard. Bosses are tapped to
receive two 1/4"- 20 screws. Fasten bracket assembly to wheel guard with two screws provided with
eyeshields.
GROUNDING INSTRUCTIONS
WARNING
Improper connection of equipment grounding conductor can result in the risk
of electrical shock. Equipment should be grounded while in use to pro- tect operator from
electrical shock.
Check with a qualified electrician if grounding instructions are not under- stood or if in doubt as to
whether the tool is properly grounded. This grinder is equipped with an approved 3-conductor cord
rated at 300V. Do not remove or alter grounding prong in any manner. In the event of a malfunction or
breakdown, grounding provides a path of least resistance for electrical shock.
WARNING
Do not permit fin-gers to touch the terminals of plug when installing or removing
from outlet.
Plug must be plugged into matching outlet that is properly installed and grounded in accordance with
all local codes and ordinances. Inspect tool cords periodically, and, if damaged, have repaired by
an authorized service facility. Green (or green and yellow) conductor in cord is the grounding wire. If
repair or replacement of the electric cord or plug is necessary, do not connect the green (or green and
yellow) wire to a live terminal.
Installation
POWER SOURCE
12" grinder is prewlred for 230 volts, 60 Hz, single-phase power. A qualified electrician should wire a
230 volt, 20 AMP, 3-prong plug to grinder line cord.
WARNING
All electrical connec- tions must be per- formed by a qualified electrician.
EXTENSION CORDS
1. The use of any extension cord will cause some drop in voltage and loss of power.
2. Wires of the extension cord must be of sufficient size to carry the current and maintain adequate
voltage.
3. Running the unit on voltages which are not 10% of the specified voltage may cause
overheating and motor burn-out.
4. Use the table to determine the mini- mum wire size (A.W.G.) extension cord.
5. Use only 3-wire extension cords hav- Ing 3-prong grounding type plugs and 3-pole receptacles
which accept the tool plug.
6. If the extension cord is worn, cut or dam- aged in any way, replace it immediately.
EXTENSION CORD LENGTH
Wire Size A.W.G.
Up to 25 ft. 14
NOTE: Using extension cords over 25 ft. long is not recommended.
ELECTRICAL CONNECTIONS
WARNING
All electrical connec-tions must be per- formed by a qualified electrician. Make
sure tool is off and disconnected from power source while motor is mounted, connected,
reconnected or anytime wiring is inspected,