©
2013 Magnum Energy, Inc
.
Page ii
Product Safety Information
IMPORTANT PRODUCT SAFETY INFORMATION
SAVE THESE INSTRUCTIONS
THIS MANUAL CONTAINS IMPORTANT INSTRUCTIONS FOR THE MS-PE SERIES INVERTER/
CHARGER THAT SHALL BE FOLLOWED DURING THE INSTALLATION AND OPERATION
OF THIS PRODUCT. Before using the MS-PE Series, read all instructions and cautionary
markings. Also, be sure to review the individual manuals provided for each component
of the system. The installation instructions are for use by quali
fi
ed personnel only. Do
not perform any installation or servicing other than that speci
fi
ed in this owner’s manual
unless you are quali
fi
ed to do so. Incorrect installation or servicing may result in a risk
of electric shock,
fi
re, or other safety hazard.
Safety Precautions
• This manual contains important safety instructions that must be followed during the installation
and operation of this product.
• All electrical work must be performed in accordance with local, state, and federal electrical codes.
• Read all instructions and safety information contained in this manual before installing or using
this product.
• This product is designed for indoor/compartment installation. It must not be exposed to rain,
snow, moisture, or liquids of any type.
• Use insulated tools to reduce the chance of electrical shock or accidental short circuits.
• Remove all jewelry such as rings, watches, bracelets, etc., when installing or performing
maintenance on the inverter.
• Always disconnect the batteries or energy source prior to installing or performing maintenance
on the inverter.
• Live power may be present at more than one point since an inverter utilizes both batteries
and AC.
• Always verify proper wiring prior to starting the inverter.
• There are no user-serviceable parts contained in this product.
• This unit is provided with integral protection against overloads.
• The input and output AC and DC circuits are isolated from the inverter chassis. The inverter
system grounding is the responsibility of the installer in accordance with industry standards
and local codes.
• Both AC and DC overcurrent protection
must
be provided as part of the installation.
• Use Class 1 wiring methods for
fi
eld-wiring connections to terminals of a Class 2 circuit.
• Use only copper wires with a minimum temperature rating of 90°C.
• Listed or labeled equipment shall be installed and used in accordance with any instructions
included in the listing or labeling.
