2
UNPACKING
Unpack the instrument carefully. Make sure all components
have been removed from the foam protection. Inspect all
components for damage. Report any concealed damage to
the carrier within 24 hours. Check the contents of the car-
ton/crates against the packing slip and report any discrep-
ancies to Magnetrol. Check the nameplate model number
to be sure it agrees with the packing slip and purchase
order. Check and record the serial number for future refer-
ence when ordering parts.
Cut and remove the plastic shipping straps on flanged units.
MOUNTING
Nameplate:
- model number
- serial n°
- tag n°
2" NPT Tuffy
External cage mounted Tuffy
Flanged Tuffy
Flanged
max nozzle length:
85 mm (3.35")
Field adjustable
differential
max nozzle length:
110 mm (4.35")
Interface
max nozzle length:
147 mm (5.80")
Threaded
max nozzle length:
84 mm (3.29")
Cage
mounted
Air
Oil
Water
Locking screw, loosen before removing cover
(refasten after replacing)
Locking screw, loosen
before removing cover
(refasten after replacing)
Cable entry should
always be pointing
down
Apply Teflon tape or
appropriate lubricant
Use wrench size 65 mm
1. Install a proper gasket.
2. Cut and remove the
shipping straps, slide
the control in the
nozzle and align the
bolt holes.
3. Cable entry should
always be pointing
down
4. Fasten bolts and
studs in a star pattern
CL
CL
CL
Pressure
vessel
Drain valve
Cable entry
should
always be
pointing
down
Safety
check
valve
Shut-off
valve
Shut-off
valve
Note: min nozzle size is 3" SCH 80 (max nozzle lengths are specified as per this size)
0038
0344
These units are in conformity with the provisions of:
1.Directive 2014/34/EU for equipment or protective system intended for use in potentially explosive
atmospheres. EC-type examination certificate number ISSeP10ATEX032 (Ex d units) or
KIWA18ATEX0022X (Ex i units).
2.The PED directive 2014/68/EU (pressure equipment directive). Safety accessories per category IV
module B + D.
SPECIAL CONDITIONS FOR ATEX INTRINSICALLY SAFE USE
When the product is installed in an area requiring EPL Ga and the enclosure is made of aluminium, all precautions shall be
taken in order to avoid all impacts or frictions which can result in the ignition of the potentially explosive atmosphere.
Install cage so that tappings
are within 3° of vertical in all directions.
