Magnetrol STI Echotel Trident 91S, Инструкция и список запасных частей, Страница: 19 / 20

19
REPLACEMENT PARTS
Part Number
No. Description
120 VAC 240 VAC 24VDC 12VDC
Single Pt. Relay 030-2184-003
1* Amplifier Board
Dual Pt. Relay
Master (Top) 030-2184-003
Slave (Bottom) 030-2184-004
Single—two-wire 030-2184-001
Dual—two-wire
Master (Top) 030-2184-001
Slave (Bottom) 030-2184-002
2*
Single Point Power Supply 10 Amp DPDT 030-2445-001 030-2445-003 030-2445-007 030-2445-005
PC Board
Opto-Isolated 030-2445-002 030-2445-004 030-2445-008 030-2445-006
3*
Dual Point 10 Amp DPDT 030-2446-001 030-2446-002 030-2446-004 030-2446-003
Power Supply PC Board
Opto-Isolated 030-2446-006 030-2446-007 030-2446-008 030-2446-009
NEMA 4X/7/9, Aluminum sand cast 002-6204-600
4 Housing Cover NEMA 4X/7/9, Aluminum die cast Group B 004-9174-007
NEMA 4X/7/9, 316 Stainless steel 002-6204-605
5 Cover Seal O-Ring 012-2101-345
NEMA 4X/7/9, Aluminum sand
004-9104-003
cast, Single conduit (
3
⁄
4
" NPT)
NEMA 4X/7/9, Aluminum sand
004-9182-003
cast, Double conduit (
3
⁄
4
" NPT)
6 Housing Base
Aluminum die cast, Double
004-9173-008
conduit, (1" NPT)
NEMA 4X/7/9, 316 Stainless steel
004-9140-002
Single conduit, (
3
⁄
4
" NPT)
7 Remote Transducer Housing
Aluminum sand or die cast 004-9105-001
316 Stainless steel 004-9142-001
8 Remote Cover Seal O-Ring 012-2101-345
Aluminum sand cast, Single
004-9104-001
9 Remote Transducer Base
conduit, (
3
⁄
4
" NPT)
316 Stainless steel, Single
004-9140-001
conduit, (
3
⁄
4
" NPT)
10 Remote Transducer Termination
Mounting bracket 005-6634-001
Board Bracket
11* Transducer Termination Board Remote PCB 030-2172-001
12 Remote Electronics
Mounting bracket (
1
⁄
2
" NPT) 036-3805-001
Mounting Bracket
13 Coaxial Cable**
RG 178 (1 to 50 feet) 037-3155-XXX
RG 58 (51 to 300 feet) 037-3156-XXX
*
Refer to ESD Handling Procedure on page 4.
** Two pairs for dual point.
WARNING: Explosion hazard — Substitution of compo-
nents may impair suitability for hazardous locations.
WARNING: Explosion hazard — Do not disconnect
equipment unless power has been switched off, or the
area is known to be nonhazardous.
Figure 28
Transducer replacement parts
1a. Order the 9X1 Transducer model
number from the unit’s name-
plate.
1b. Construct part number from
Transducer Part Number section
under Model Identification from
pages 1 or 2.
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
4
5
13
12
6
2
1
3
Figure 26
10
11
7
8
9
Figure 27