Device lay out
1)
Warning Light : device operating conditions, vehicle’s connection status, memory status (memory full), working state and
so on.
2)
USB port for PC connection.
VEHICLE SET UP AND USE
ATTENTION FOR CORRECT USE
It is always needed to check the complete functionality of all safety systems present on-board (es.: AIRBAG, ABS etc.), after
installing the device.
LOCATION OF THE OBD CONNECTOR
The standard EOBD connector has to be present on board in all gasoline vehicles starting form 2001. Normally the EOBD connector
is located into the vehicles somewhere round the driver site. The connector sometime could be located behind a plastic cover.
Through the SW installed on the PC, by selecting the option “OBD Diagnosis” and after selecting the vehicle will be displayed the
right position of the Diagnostic connector.
INSTALLTION/REMOVAL OBD-ROAD
The Device connection and disconnection have to be safely complete with the engine off and the dashboard off since 1 minute at
least.
HOW TO CONNECT THE OBD ROAD DEVICE
1.
The Engine and the Dashboard have to be off.
2.
Find out the location of the OBD connector.
3.
Make use of the right tools for removing safely all the parts necessary to protect the EOBD connector.
4.
Plug the Device into the EOBD connector and make sure it is steadily connected.
5.
Reassemble all the parts took off before (plastic cover, panel an so on)
