Magnetek Impulse G+ series 4, Техническое руководство

Страница: 152 / 248

IMPULSE•G+/VG+ Series 4 Technical Manual
November 2022
Page 152
5.6.4 Analog Inputs
The VFD has three built-in analog inputs for the external input of references and limits.
Table 5-81: Analog Inputs Parameter Settings
* Initial value is determined by X-Press Programming (
Table 4-6 on page 58
,
Table 4-7 on page 59
or
Table 4-8 on page 60
).
Parameter Display Function Range Default
H03-01 Term A1 Signal Terminal A1 analog input signal 0, 1 *
0 0 to 10 V
1 -10 to 10 V
H03-02 Terminal A1 Sel Function of terminal A1 (
see Table 5-82 on
page 153
and
Table 5-83 on page 154
)
0–31 0
H03-03 Terminal A1 Gain Gain multiplier for Terminal A1 analog input -999.9–999.9% 100.0
H03-04 Terminal A1 Bias Bias multiplier for Terminal A1 analog input -999.9–999.9% 0.0
H03-05 Term A3 Signal Terminal A3 analog input signal 0, 1 0
0 0 to 10 V
1 -10 to 10 V
H03-06 Terminal A3 Sel Function of terminal A3 (
see Table 5-82 on
page 153
and
Table 5-83 on page 154
)
0–31 1F
H03-07 Terminal A3 Gain Gain multiplier for Terminal A3 analog input -999.9–999.9% 100.0
H03-08 Terminal A3 Bias Bias multiplier for Terminal A3 analog input -999.9–999.9% 0.0
H03-09 Term A2 Signal Terminal A2 analog input signal 0–3 2
0 0 to 10 V
1 -10 to 10 V
2 4 to 20 mA
3 0 to 20 mA
NOTE:
Use DIP switch S1 to set input terminal A2 for a current or a
voltage input signal.
H03-10 Terminal A2 Sel Function of terminal A2 (
see Table 5-82 on
page 153
and
Table 5-83 on page 154
)
0–31 1F
H03-11 Terminal A2 Gain Gain multiplier for terminal A2 analog input -999.9–999.9% 100.0
H03-12 Terminal A2 Bias Bias multiplier for terminal A2 analog input -999.9–999.9% 0.0
H03-13 Filter Avg Time Analog input filter average time 0.00–2.00 sec 0.03
H03-14 A1/A2/A3 Sel Determines which analog input terminals will be
enabled when a digital input programmed for
“MFAI Enable” (H01-xx = 3A) is activated. 1–7 7
1 A1 Available
2 A2 Available
3 A1/A2 Available
4 A3 Available
5 A1/A3 Available
6 A2/A3 Available
7 All Available
H03-16 TerminalA1Offset Adds an offset to terminal A1 -500–500 0
H03-17 TerminalA2Offset Adds an offset to terminal A2 -500–500 0
H03-18 TerminalA3Offset Adds an offset to terminal A3 -500–500 0