4
11. AC POWER Connect the SA-4 to an AC power source only of the type describe in these
operating instruction or as marked on the rear panel of the unit.
Make sure to have the proper power voltage rating to match with your SA-4.
12. FUSE Replace only with same type of fuse as marked on the rear panel.
Functions
1 2 3 4
5 6 7
8
1. POWER Pressing the POWER button once on the front panel will turn the machine on.
The LED on the front panel will light up when the machine in ON.
Press POWER again to turn the machine OFF. The LED will fade off when the power is off.
2. BALANCE Turning the balance level will lower your output level left/right. Leaving it in
the center will give you equal output on both channels. Sometimes in unequal source
recording, you may need to adjust the balance level to get a balanced stereo image.
3. TONE Press the TONE switch to activate TREBLE and BASS circuitry. When not
engaged (not pressed in) the signal will bypass the TONE circuitry.
4. BASS
For adjustment of lower tone. Turning the BASS level will boost or cut the bass
level of your output . Leaving it in the center will give you a flat frequency response output.
5. TREBLE For adjustment of higher tone. Turning the TREBLE level will boost or cut the
treble level of your output. Leaving it in the center will give you a flat frequency response
output.
6. TAPE
Press the Tape switch once to select TAPE input as the source. Press TAPE once
more to un-selected TAPE mode.
7. CD/TUNER/LASER/VIDEO/LINE/TAPE Turn the select knob to your desired source input.
8.
VOLUME For adjust of the output level.
