Magnescale LY71, Инструкция по установке и эксплуатации

Страница: 77 / 104

LY71
(E)
4-7
4. Settings
Setting contents
Display Setting item Available options Remarks
Display at Count display after power ON
power ON (factory setting) display after power ON
(used to detect power supply
interruptions)
Display resolution (Select polarity with key) (Supports the selected polarity)
and polarity 0.1
µ
m
0.5
µ
m
1
µ
m
5
µ
m
10
µ
m
Angle 1 s
Angle 10 s
Angle 1 min
Angle 10 min
<Expanded selection options
are shown below>
0.05
µ
m
2
µ
m
20
µ
m
25
50
µ
m
100
µ
m
Angle 1 degree
∗
The initial value is the same as
the measuring unit resolution
set by the basic settings.
Display axis, and Displays the current value of the
display data at (Factory setting for display A) first axis input
power ON Displays the maximum value of
(Factory setting for display B) the first axis input
Displays the minimum value of
(Factory setting for display C) the first axis input
Displays maximum value –
minimum value
∗
To turn off the display, set
. However, you cannot
turn off all the counter displays
at the same time.
Scaling to Numerically input the
(Factory setting ) magnification.
Linear to
±
Numerically input the
compensation (Factory setting 0) compensation value. (Unit:
µ
m)
∗
Numerical value of measuring
<Expanded selection option> unit resolution
to Example: When the measuring
unit resolution is
0.001 mm, the
compensation value
applies to the three
digits below the
decimal point, and
can be set in the
range from –1.000 to
1.000.