*NOTE: This dimension is for an average person sitting in an average chair. You should adjust the
speaker up or down for your height and seating. Ideally, your ears and the center of the speaker
should be at the same level.
MMG W WALL BRACKET INSTALLATION
1. Locate holes on stud or use hollow wall anchors as shown.
2. Use level to check vertical alignment.
3. Drill holes – 5/16" for hollow wall anchors or 3/32" for wood screws.
4. Fasten brackets to wall as shown.
5. Put rubber washer onto bottom bracket post.
6. Install speaker by setting it on the bottom post while feeding wires through hollow center of
post. Pull excess wire through lower bracket and set speaker on bottom post.
7. Align hole in top of speaker with hole in top bracket and insert clevis pin.
MMG W INVERTED INSTALLATION
The MMG W may be installed in an inverted position (if you wish to have the wires exit at the top of
the speaker). Invert the brackets during installation. Since the pin may fall out in an inverted position,
Magnepan will provide a special friction pin upon request.
