MagneMotion MagneMover LITE, Руководство пользователя, Страница: 333 / 382

Maintenance
Repair
MagneMover LITE User Manual 49
Rockwell Automation Publication MMI-UM002E-EN-P - March 2016
Removing Vehicles Without Removing Rails
The single or dual array vehicles can be removed from the Precision Rail system without
removing any of the precision rail sections. Note that removing vehicles in this manner will
require adjustment of the vehicle’s bearings after it is re-installed on the rail.
1. Stop all motion on the section of the MagneMover LITE transport system where the
vehicle will be removed.
2. Remove the lubricating applicator from the bottom of the vehicle ( Replacing Lubricat-
ing Applicators on Vehicles on page 7-50 ).
3. Using a socket wrench, loosen the nuts on the eccentric bearings on the top of the vehi-
cle (refer to
Figure 7-17 ).
4. Using a thin open ended wrench, turn the bearing nut to rotate both eccentric bearings
to their outermost position.
5. Slowly roll the magnet array side of the vehicle up and off of the rail as shown in Fig-
ure 7-19 .
NOTE: Once vehicles are removed from the transport system they must be stored in
their original packaging to protect the vehicle and to minimize any safety
risks.
Figure 7-19: Remove Precision Rail Vehicle From Rail
6. Return the MM LITE transport system to normal operation.