MagneMotion MagneMover LITE, Руководство пользователя, Страница: 324 / 382

Maintenance
Repair
40 MagneMotion
Rockwell Automation Publication MMI-UM002E-EN-P - March 2016
OPTIONAL
A. Remove the protective strip from the magnet assembly.
B. Clean the magnet assembly using isopropyl alcohol to remove any residue.
C. Place the new protective strip on a flat surface with the adhesive side up and
remove the adhesive protective backing from the strip.
NOTE: If a PTFE protective strip was used it will be replaced with the new
UHMW protective strip.
D. Carefully center the magnet array over the center of the adhesive strip. Fold
both ends of the strip over the sides of the array. Then fold the holes at each
end of the strip over the threaded standoffs as shown in
Figure 7-11 .
NOTE: Do not stretch the protective strip. Stretching will reduce the life of
the adhesive, causing the strip to peel away from the array.
E. Press the strip into place using a burnisher, ensuring there are no bubbles.
5. Remove the backing from the glue dot and apply the glue dot to the center surface of
the preload spacer as shown in
Figure 7-12 .
6. Locate the preload spacer on the center hole on the underside of the top plate, ensuring
the surface with the glue dot is fully seated and adhered to the top plate.
7. Align the top plate with the center plate and press together as shown in Figure 7-12 .
Figure 7-12: Adhere Preload Spacer to Underside of Top Plate
Center Plate
G5 Spacer
Glue Dot
Top Plate