MagneMotion MagneMover LITE, Руководство пользователя, Страница: 120 / 382

Specifications and Site Requirements
Motor Types
2 MagneMotion
Rockwell Automation Publication MMI-UM002E-EN-P - March 2016
Motor Types
MagneMover LITE G3 Motors
The MM LITE G3 series motors and switches have been replaced by the G4 series motors and
switches. The G4 series motors and switches are fully backward compatible with the G3
series.
MagneMover LITE G4 Motors
The MagneMover LITE motor bodies are available in two styles; motors with integral rails
and railless motors. Both body styles perform the same and have the same operating specifica-
tions. Note that switches are only available with integral rails. The integral rails are available
in either aluminum or stainless steel.
• All motors allow up to nine (9) 62 mm vehicles (pucks) in motion per meter.
1
• All motors allow up to twelve (12) 62 mm vehicles (pucks) in a queue per meter.
1
• Shortest magnet array allowed is 1 cycle (standard 62 mm puck).
• Thrust at nominal Vehicle Gap is 6 N/cycle at 25% duty cycle.
2
• Motor block length is 16.47 mm.
• Internal motor controller.
• Refer to Table A-2 on page A-4 for acceleration, velocity, thrust, and payload limits.
1. Maximum number of vehicles (pucks) per meter is determined using the standard single array puck on a straight
motor. Using a dual array (tandem) vehicle or a curved motor will decrease the number of vehicles allowed per meter.
2. Nominal Vehicle Gap (distance between the magnet array and the motor) is 1 mm for G3 magnet arrays and 1.5 mm
for G4.2 and later magnet arrays.