AIR CONDITIONER FEATURES
Before you begin, thoroughly familiarize yourself with the control panel and remote controller
and all its functions, then follow the symbols for the functions you desire.
The unit can be controlled by the unit control panel itself with the remote control.
ELECTRONIC CONTROL OPERATING INSTRUCTIONS
Fig.4
NOTE: This manual does not include Remote Controller Operations, see the <<Remote
Controller Instruction>> packed with the unit for details.
OPERATION PANEL OF THE AIR CONDITIONER
6
2
3
4
7
8
1
Selects the operating mode. Each time
you press the button, the mode cycles through
the following sequence: AUTO, COOL, DRY,
FAN and HEAT(not available on cooling only
T
models). he mode indicator light illuminates
according to the mode selected. Fig.4.)
(
MODE select button
1
Used to adjust (increasing/decreasing)
temperature settings(one degree increments)
in a range of 17 C(62 F) to 30 C(88 F) or
the TIMER setting.
6
UP( ) and DOWN( ) button
NOTE:
The control is capable of displaying
temperature in Fahrenheit or Celsius.
To convert from one to the other, press and
hold the Up and Down buttons at the same
time, for 3 seconds.
3
Used to initiate the AUTO ON start time and
AUTO OFF stop time program, in conjuction
with the & buttons.
TIMER button
4
Used to initiate the SLEEP mode.
SLEEP button
6
2
Power switch on/off.
POWER button
AUTO
HEAT
COOL
DRY
FAN
MODE
ION
SLEEP
FAN
TIMER ON
TIMER OFF
F
C
5
FAN button
7
O
Shows the set temperature in C or
O
F and the Auto-timer settings.
While on DRY and FAN modes, it shows
the room temperature.
LED Display
SWING
Remote signal receptor
(Some models have the
signal receptor on the
front panel , Fig.2)
9
(Only available on
models with auto-
swing feature)
Error codes and protection code:
E1-
Room temperature sensor error-
Unplug the unit and plug it back in.
If error repeats, call for service.
E2-
Evaporator temperature sensor error-
Unplug the unit and plug it back in.
If error repeats, call for service.
E4-
Display panel
communication
error-
Unplug the unit and plug it back in.
If error repeats, call for service.
P1-
Bottom tray is full
- Connect the
drain hose and empty the collected
water. If error repeats, call for service.
5
HI
MED
LOW
5
Controls the fan speed. Press to select the fan
speed in four steps-LOW, MED, HI and AUTO.
The fan speed indicator light illuminates the
corresponding fan settings except AUTO . On
AUTO fan speed, all fan indicator lights will be off.
