1.
Connect the external Audio Device with a 3.5mm AUX cable. (Cable not
included).
2.
Insert one end of the AUX cable to the Phone; Line Out or AUX Out Jack on the
external Audio player.
3.
Power on the unit from Standby mode by press the POWER Button on the unit
to select AUX In mode
.
Insert the other end of the AUX cable into the
AUX In
Port
on the
front
of unit.
“AU
X
” indicator will appear
on the display.
4.
Play the music on the connected Player as usual. (Make sure the volume level of
the connected Audio Player is turned to high level.)
AUX
IN:
Antennas:
AM – This unit has a build in ferrite rod antenna, which provides adequate reception
in most
areas. If reception is weak, turn the unit to improve reception.
FM – The FM Wire Antenna is for FM reception only. If reception is weak, unwound
and relocation
the wire antenna.
1.
Power on the unit and enter to Radio mode as previously instructed. “AM” or “FM”
indicator and the radio frequency will appear on the display.
2.
Press th
e
or
Button to select the radio
station
as desired.
AM/FM
RADIO:
1.
Find the
AM/FM
radio station you would like to save.
2.
Press the MEMORY Button on the main unit or MEMORY Button on the remote
control.
3.
Press
or
buttons to select the preferred Preset Number,The display will show
"P01, P02, etc..."
4.
Press the MEMORY Button on the main unit or press MEMORY Button on remote
control again to save the station.
5.
Repeat steps 1-4 until you have finished saving your presets.
6.
To navigate through the stored presets, press the MEM+ or MEM- Buttons.
SETTING
AM/FM
RADIO PRESETS
:
Notes:
z
I
f stereo FM radio station is receiving in FM band. The FM stereo indicator
"
"
will
appear on the display automatically.
z
This unit can store up to 30 FM radio stations and 20 AM radio stations presets
1
7
1.
Press and hold
Play/Pause Button for 2 seconds
2.
The unit will auto scan available station in AM or FM band and store in the
preset memory.
3.
To navigate through the stored presets, press the MEM+ or MEM- Buttons.
AUTO SCAN RADIO
:
