CLOCK MEMORY BACKUP
The clock memory backup allows your alarm and clock time settings to be stored
for up to a day when there is a power interruption e.g. power failure. The com-
plete clock radio and display illumination will be switched off. As soon as the
power supply returns, the display will indicate the correct time.
1
Remove the battery door to insert a
9 volts 6F22
type battery (not included)
for backup.
2
Replace the battery door.
NOTE:
If no backup battery is installed or the power interruption is prolonged,
you will need to set the clock and alarm times again.
Batteries contain chemical substances so they should be disposed of
properly.
Standby power consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2W
RADIO
You can use this set solely as a radio!
1
Adjust
OFF/ ON/ AUTO/ BUZZ
to
ON
to switch on the radio.
2
Select your waveband by adjusting the
FM/AM
switch.
3
Adjust
TUNING
to tune to your desired station.
4
Turn the
VOLUME
control to adjust the volume level.
5
Adjust
OFF/ ON/ AUTO/ BUZZ
to
OFF
to switch off the radio.
To improve reception:
FM:
use the antenna built in the power cord. Adjust the position of the
power cord for optimum reception.
AM:
uses a built-in antenna inside the set. Direct the antenna by adjust-
ing the position of your set.
SETTING THE CLOCK TIME
The time is displayed using the 12-hour clock with PM indicator (PM off = AM).
1
Hold down
SET TIME/ALARM OFF
.
2
Press
TIME SET
3
or
4
repeatedly, or hold down
TIME SET
3
or
4
to
adjust minute and/or hour.
-
TIME SET
3
: to adjust time fast forward
-
TIME SET
4
: to adjsut time back
3
Release
SET TIME/ALARM OFF
and
TIME SET
3
or
4
when you reach the
correct setting.
™
The set clock time will show on the display and start to run.
USING THE ALARM
This set allows you to set one alarm (alarm 1 or alarm 2), or set two alarms
simultaneously. This set also offers you two alarm modes: Auto (radio) and Buzz.
SETTING THE ALARM TIME
1
Hold down
SET ALARM 1
or
SET ALARM 2
2
Press
TIME SET
3
or
4
repeatedly, or hold down
TIME SET
3
or
4
to
adjust minute and/or hour.
3
Release
SET ALARM 1
or
SET ALARM 2
, and
TIME SET
3
or
4
when you
reach the desired time setting. The display will return to the clock time.
SELECTING THE ALARM MODE
1
Adjust
AL1/AL2/AL1+2
to
AL1
(alarm 1), or
AL2
(alarm 2), or
AL1+2
(alarm 1
+ alarm 2) .
2
Select your choice of alarm mode by adjusting
OFF/ ON/ AUTO/ BUZZ
to
AUTO
or
BUZZ
.
™
The corresponding alarm indicator(s) will light up.
Helpful Hint:
• If you have selected the radio mode, make sure you have adjusted the volume
loud enough to wake you.
• The buzzer is set at a fixed volume and cannot be adjusted.
MCR140-37-EN 12/6/07 14:04 Page 6