Installing the stands
1
Remove both of the bottom polystyrene foam bases. Carefully
tear the plastic bag until the bottom corner of the TV is
exposed.
●
Support the top of the TV set at all times to prevent the TV
from falling.
Caution(s)
●
Before installing the matching stand, remove the protective cardboard and
carefully peel away the film from the area so that it will not get stuck
between the unit and the stand.
2
Lift up one side of the TV approx. 1 inch (2.5 cm) and insert
the matching stand upward until it fits the main unit.
3
Fasten the matching stand to the TV with 2 screws (included).
2 screws
required
4
In the same manner as step 2, install the other stand.
5
Fasten the other stand to the TV with 2 screws (included).
2 screws
required
6
Both stands should now be securely fastened.
Note(s)
●
A wide open space is recommended for assembly.
●
A Phillips-head screwdriver is required to fasten the stands to the TV set.
●
When attaching the stand, ensure that all screws are tightly fastened. If the
stand is not properly attached, it could cause the unit to fall, resulting in
injuries as well as damage to the unit.
●
To remove the stand from this unit, unscrew the phillips-head screws by
reversing the procedure. Be careful not to drop the stand when you remove
it.
10
.
English
Continued on next page.
