Magnasonic SelfSet MM176K, Руководство пользователя

Страница: 8 / 19

- 14 - - 15 -
TROUBLESHOOTING
If you experience a problem with this unit, check the chart below before calling
for service.
SYMPTOM POSSIBLE CAUSE POSSIBLE SOLUTION
GENERAL
Power does not come on AC cord not plugged in Insert plug firmly into AC outlet
RADIO
No sound
Power is not on Press power to turn the radio on
Volume control is at the
minimum position
Turn the volume control up
Noise or sound is distorted on
AM or FM radio
AM: Interference
Position the radio for better AM
reception
FM: Antenna wire not extended Extend antenna wire
CLOCK
Incorrect time
Batteries inserted incorrectly,
not connected or dead
Check batteries
Clock not set Set the clock
Alarm does not turn on
Alarm is not set to turn on
Press and hold ALARM 1 or
ALARM 2 to turn on the alarm
Clock is not set Set the clock
Alarm time is not set Set alarm time
SPECIFICATIONS
Frequency Range (AM) 520 - 1710 kHz
Frequency Range (FM) 87.5 - 108 MHz
Power Supply AC 120V ~ 60Hz, 5W
Battery Backup DC 3V CR2032 (battery included)
Indoor Temperature Range 0 to +50°C or 32 to 122 °F
Specifications are subject to change without notice.
CARE AND MAINTENANCE
PRECAUTIONS:
1. Always turn off the unit after use.
2. Keep the unit away from magnetic objects, water or heat sources.
3. Use a clean soft cloth moistened with lukewarm water to clean the
cabinet. Never use chemical cleaners that could damage the finish of the
unit.
4. Disconnect the unit from any power sources before cleaning.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.