Magnadyne PL61 Скачать руководство пользователя страница 5

5

Remote Panic

Press and hold the PANIC button for more than 3 seconds and the security system will respond in the

following manner:

A. The horn/siren will begin sounding.

B. The parking lights will begin flashing. 

To turn off the panic alarm, press and release the ARM/DIS or PANIC button on the transmitter. The

horn/siren will stop sounding and the parking lights will stop flashing.

Note 1: If you do not turn off the panic feature with the transmitter, the panic alarm will sound for 60

seconds and then turn off by itself.

Note 2: If your PANIC button       has been programmed to operate a channel #3 controlled function –

Panic operation will be switched to the LOCK button    . The procedure to activate panic is the same

as explained.  

User Discretion Silent Arming 

Your security system can be instructed to become armed or disarmed without the horn/siren chirps by the

remote transmitter. To operate this feature at any time, simply press:

Press the LOCK and UNLOCK button at the same time.

The combination of the two signals will instruct the security system to arm or disarm silently.

60 Second Re-Arming:

If your security system has become triggered, the horn/siren will sound for 60 seconds and then stop and re-

set to a fully armed condition.

Note: If a protected entrance is left open, your security system will remain triggered for two more 60 second

cycles then fully re-arm excluding the door input trigger. (Door input trigger is no longer functional) Closing the

entrance will re-set the door input trigger within 7 seconds.

Secondary RF Protection Mode

Every time you disarm your security system with your transmitter, the security system will start an RF

protection mode countdown. This is a timed secondary protection mode to insure that the radio signal used to

disarm the security system was from your transmitter. After the system is disarmed by radio signal, it will

count down for 60 seconds and then become re-armed if no one enters the vehicle.

Note: The feature is only active when security system has been programmed to automatically arm.

Содержание PL61









Отзывы: