Magnadyne M9, Руководство пользователя, Страница: 22 / 32

20
Device Connections
Notes of connection
voltage is appropriate for this unit to be used, otherwise, have a professionally installed
transformer to convert the output voltage to 12V.
disconnected before installation.
To prevent short circuit in the wiring and damaging to this unit, secure all wirings with cable
clamp or adhesive tape. Route the wirings in a secured, out of heating place without touching
being melted / worn off.
Never pass the yellow power cord through the installation hole into the engine compartment and
connect to the car battery. Otherwise, a high possibility of serious short circuit to the electrical
system may occur.
If you need to replace the fuse, please replace with a 15A fuse. Using no fuse or a fuse with an
problems continue to occur, please contact your local retailer or installer.
DO NOT connect other equipments with the car battery to avoid battery overheating.
Otherwise, this unit may be damaged by short circuit.
If there is no ACC available, please connect ACC lead to the power supply with a switch.