Remote Control Touch / blue PiraT Re-
mote
User Guide
Datum:14.12.2018
Seite 42 von 82
RCTouch_UserGuide_V3.4.1.doc
6.2.3.3
Busload - GPS
Each connected logger that receives GPS data generates its own tab sheet
[GPS]
with the fol-
lowing displays:
Figure 6.23: Tab sheet
“GPS”
Figure 6.24: Tab sheet
“GPS” – continuation
If the window contains only the display of “No GPS signal”, this may be for at least one of the
following reasons:
The GPS connection is disabled.
The GPS receiver is not connected.
No satellite or too few satellites were found (minimum 3).
Figure 6.25: Tab sheet
“GPS”: No GPS signal
Latitude
Longitude
Altitude above sea level
Course/direction
Speed
Longitude
Altitude above sea level
Course/direction
Speed
No. of satellites found