Magna-Matic Corporation - W4599 County Road IW - Waldo WI 53093 USA - Phone: (920) 564-2366 - FAX: (920) 564-2368 - Toll Free USA & Canada
1-800-328-1110
http://
www.magna-matic.com
- email: [email protected] © Copyright 2023 All rights reserved
Quick Setup Guide
WARNING
WHEN USING ELECTRIC TOOLS, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, AND PERSONAL INJURY.
CAUTION
TURN OFF AND UNPLUG
BEFORE SERVICING
Page 8
Water-Cooling Kit Assembly
Unpacking and mounting tank, and charging coolant.
Installing the tank
1. When building the stand bolt the tank shelf on the bottom set of (3) holes
on the column below the sharpener.
2. Set tank on shelf, use (4) 5/16 bolts and washers to secure tank to shelf.
Preparing the Tank
1. Take the cap off the tank (this can be used for storage to keep coolant from
evaporating during off-season)
2. Remove filter sock, and packaging from inside the tank.
3. Double check the hose is still connected to the pump and didn’t slip off
during shipping.
Connecting to sharpener
1. The clear vinyl tubing from the tank connects to the hose barb behind the
sharpeners electric motor, secure with loop connector.
2. The power cord for the pump plugs into the outlet on the electric panel of
the sharpener. This outlet is switched by the blue switch.
3. There is a red valve on the front of the sharpener to regulate how much
coolant is delivered to the wheel.
4. Always turn off the grinding wheel when adjusting coolant nozzle.
5. Make sure to adjust the nozzle of the coolant before running the grinding
wheel. It may have shifted during shipment. Adjust the coolant nozzle to
deliver coolant to the grinding wheel.
Preparing the Coolant
1. Double check the vinyl hose is connected to the pump.
2. Measure a 1/2 gallon of coolant, and pour into tank.
3. Fill tank with 5 gallons of tap water.
4. Put the filter sock into the tank, the metal ring will stop it from falling in.
5. Push the yellow spiral hose into the filter sock, a few yellow ribs should be
inside the neck of the tank.
6. Slip the top of the yellow sprial hose onto the water tray metal inlet.
7. Turn pump on, open valve slightly to test coolant system, check for leaks.
Call with any questions!
800-328-1110
LOOK
INSIDE THE TANK
We put packaging
foam inside the tank
to prevent the pump
from banging around.
Also the clear vinyl
tubing and other parts
are inside there.
